Heating during a renovation
When a house is being rewired and replumbed, the heating system is usually the third element of the same decision. New pipework and radiators can be run to the right positions for the new layout, and controls can be placed where they are actually useful rather than where the old system happened to leave them.
We install heating as part of the wider project, coordinating it with the plumbing and electrical work so the boiler, cylinder, pipework, radiators and controls are planned as one system.
Radiators, controls and zoning
Radiator sizing and position determine whether a room heats evenly. Controls determine how much you spend doing it. We plan radiator positions with the furniture layout in mind, and set controls so different parts of the house can be heated when they are used.
An honest conversation about the system
We will discuss what your existing system is, what condition it is in and what is worth replacing. Where a change requires work by a specialist or a registered installer for the appliance in question, we will tell you that rather than implying otherwise.
What the work covers
- Heating system installation during renovation
- Radiator supply and installation
- Heating pipework and first fix
- Heating controls, thermostats and zoning
- Cylinder and hot water provision
- Removal of old radiators and pipework
- Balancing and commissioning
- Coordination with plumbing and electrical work
Worth thinking about before you start
- Decide radiator positions before first fix; moving them afterwards means redoing pipework.
- Where a room is being extended or reconfigured, the heat requirement changes with it.
- Agree who is responsible for any appliance-specific certification before work starts.
- Allow time for the system to be balanced properly at the end of the job.
How the project works
- Step 1
Get in touch
Call, email or send the enquiry form with a short description of what you are planning. We will ask a few questions to understand the project.
- Step 2
Visit and measure
We call out, measure the space properly and look at what is behind the walls and under the floor, so the plan is based on the actual room.
- Step 3
Free tailored quotation
You receive a quotation based on the work agreed, the specification chosen and the condition of the space. No obligation, and no pressure.
- Step 4
Work and handover
We agree a programme, carry out the work in sequence and check the finished result with you before we finish up.
Why choose Ruach Kitchens
- Over 20 years of experience in kitchens, bathrooms and building work
- One coordinated team instead of separate trades
- Free, tailored quotations based on your actual room
Where we work
We carry out this work across Dublin City and County Dublin. Our base is at Bunratty Road in Coolock, on the northside, and we travel throughout the city and county for projects.
Frequently asked questions
Can you install a new heating system as part of a renovation?
Yes. Heating installation is planned alongside the plumbing and electrical work so the pipework and controls are in the right place before the walls and floors are finished.
Do you replace radiators without replacing the whole system?
Often yes, if the existing pipework and boiler can support it. We will assess the system before recommending anything.
Can you add heating to a room that did not have it?
Usually, by extending the existing system where capacity allows. We will check the system and the route for the new pipework.